Blog > viewport 4.8.0 – error with Shift-F3

Home Forums ViewPort viewport 4.8.0 – error with Shift-F3

This topic contains 2 replies, has 2 voices, and was last updated by  Hanno .

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #12209

    Anonymous

    Hi Hanno, I upgraded to ViewPort 4.8.0, and it works great, I like it so much, my firmwares in SPIN compile with Shift-F8 without any problems.
    However, in at least one case, compilation with Shift-F8 is OK, giving Prog:7620 long, Var:409 Longs, Stack/Free:158 Long, while Shift-F3 gives an error, and I can’t download it to Propeller (see attached JPG figure).
    Note that I do not need ViewPort support, and that the same firmware compiles and is downloaded to Propeller using ViewPort 4.7.7. Moreover, no problems are encountered with
    Propeller Tool.
    Am I doing something wrong?

    Yours Carlo

    #12213

    Hanno
    Keymaster

    Hi Carlo,
    Thanks for letting me know about this- pressing “load eeprom” did indeed include ViewPort support. I’ve fixed it and will release 4.81 later today.
    Hanno

    #12245

    Hanno
    Keymaster

    Hi Carlo,
    I’ve hopefully fixed most of the forum issues related to broken links and smilies. Still investigating attachments.
    I think you asked about “create binary”- I haven’t added that yet.
    Hanno

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.